Parkside 351750 2007, Перевод оригинальной инструкции

Страница: 55 / 75

PSSA 20-Li A1
GB
│
MT
│ 51 ■
Use
Switching on and off
Switching on
♦ First press the safety lock-out and then the
ON/OFF switch . Afterwards, release the
safety lock-out .
Switching off
♦ Release the ON/OFF switch .
Adjusting the rotational speed
Press the ON/OFF switch lightly for a low
speed . Increasing the pressure increases the speed .
NOTE
► The integrated motor brake ensures rapid
stoppage .
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate can be swivelled . It must always be
in contact with the workpiece when the appliance
is running .
Practical advice on sawing
♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e .g . nails, screws, etc .
♦ Ensure that the ventilation slits are not
covered .
♦ Switch the appliance on before moving it
towards the material to be worked .
♦ Switch the appliance off immediately if the saw
blade jams .
Open up the sawn gap using a suitable tool
and pull out the sabre saw .
■ Use the appropriate saw blade and stroke
rate for the material to be worked .
■ Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes .
■ Saw the material at a constant speed .
Sawing flush to edges
Using flexible saw blades with a suitable
corresponding length, you can saw off protruding
workpieces such as pipes flush to the wall .
Proceed as follows:
1 . Place the saw blade directly against the wall .
2 . Bend it by applying lateral pressure to the sabre
saw so that the footplate makes contact with
the wall .
3 . Switch the appliance on as described and
saw off the work piece by applying constant
pressure .
Plunge sawing:
CAUTION! RISK OF KICKBACK!
■ Plunge cuts may only be made in soft
materials (wood or similar) .
Proceed as follows:
1 . Place the sabre saw with the lower edge of the
footplate onto the workpiece . Switch the
appliance on .
2 . Tilt the sabre saw forwards and plunge the saw
blade into the workpiece .
3 . Position the sabre saw vertically and continue
sawing along the cutting line .