Parkside 332971 1907, Инструкции по эксплуатации и безопасности

Страница: 45 / 194

36 GB/IE
else. Any use that differs to the intended
use as stated above is prohibited and
potentially dangerous. Damage or
injury caused by misuse or disregarding
the above warning is not covered by
the warranty or any liability on the part
of the manufacturer. The device has
been designed for household use only
and must not be used in commercial or
industrial applications. Commercial use
will void the guarantee. Observing the
safety instructions and assembly instruc-
tions and operating information in the
instructions for use is also a component
of the intended use.
It is imperative to adhere to the applica-
ble accident prevention regulations.
The device must not be used:
„
in insufficiently ventilated rooms,
„
in explosive environments,
„
to defrost pipes,
„
in the vicinity of people with cardiac
pacemakers and
„
in close proximity to easily
flammable materials.
Residual risk
Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this 4-in-1 compact welder:
„
Eye injuries due to glare,
„
Touching hot parts of the device or
workpiece (burn injury),
„
In case of improper protection risk of
accident and fire through sparks and
slag particles,
„
Harmful emissions from smoke and
gases if there is a lack of air or
if closed rooms are insufficiently
extracted.
Reduce the residual risk by carefully
using the device as intended and
observing all instruction.
z
Package contents
1 4-in-1 Compact welder 120
A1
2 Welding nozzles for steel wire
(1x 0.8 mm; 1x 0.6 mm)
1 Chipping hammer with wire brush
1 Welding mask
1 Operating instructions
1 Earth terminal with cable
1 MIG torch with welding cable
1 Flux-cored welding wire spool
450 g for inert gas welding
1 Argon gas cylinder 0.95 l
1
Pressure regulator
z
Parts description
1
Cover wire feed unit
2
Handle
3
Control dial for wire feed
4
Control dial for setting the welding
current
5
Mains plug
6
Earth cable with earth terminal
7
Torch
8
Torch button
9
Plug
10
Welding mode selector switch
11
Overload protection control lamp
12
Main switch ON/OFF
(incl. power indicator lamp)
13
Inert gas--inlet tubing
14
Pressure regulator
15
Welding nozzle (0.6 mm)
16
Welding nozzle (0.8 mm)
17
Flux-cored welding wire spool (steel)
Ø 0.8 mm / 450 g
18
Chipping hammer with wire brush
19
Feed roll
20
Shield body
21
Dark welding lens
Introduction