Parkside 307590, Перевод оригинальной инструкции

Страница: 23 / 41

PASSK 20-Li A1 GB
│
MT
│
19 ■
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger.
■ Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack to the high-speed
battery charger (see Fig. A).
♦ Insert the power plug into the socket. The control
LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready for use.
CAUTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Push the battery pack back into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also dis-
connect the power plug from the mains power
socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Push the rotation direction switch into the
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack:
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to check
the status of the battery (see also main diagram).
The status/remaining charge will be shown
on the battery display LED as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED working light lights up when the
ON/OFF switch is depressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off:
♦ Release the ON/OFF switch to switch off the
appliance.
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button to select
the required torque in stages.
♦ Press the ON/OFF switch lightly for a low
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
► However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!