Parkside 303000 1910, Перевод оригинальной инструкции

Страница: 27 / 48

PFSA 20-Li A1 ■ 22
│
GB
│
MT
Preparing the spray surface
♦ Cover the area around the spray area thoroughly
and over a wide area. Any surface that is not
masked could become contaminated.
♦ Make sure that the spray surface is clean, dry
and free of grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.
Before use
Charge battery pack (see fig. B)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
it to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level must be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Insert the battery pack into the high-speed
charger .
♦ Insert the power plug into the socket. The red
control LED lights up to indicate that the
appliance is charging.
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready.
♦ Push the battery pack into the appliance.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the battery pack into the handle until
it clicks into place.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to
check the charge level of the battery. The status
is indicated in the adjacent battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Setting up
Assembly/disassembly
♦ Move the ▸ mark on the spray unit to the
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the
mark on the motor unit .
♦ Release the catch
5a
. Turn the ▸ mark on
the spray unit to the mark on the motor
unit to separate the two units.
Selecting/changing the nozzle
Nozzle Use
1.8 mm nozzle
all types of paints and
lacquers
2.6 mm nozzle
viscous spray material
♦ Undo the union nut completely and remove
it from the spray unit .
♦ Fit the desired nozzle onto the nozzle
head .
♦ Screw the union nut back onto the spray
unit .