Parkside 303000 1910, Перевод оригинальной инструкции

Страница: 26 / 48

PFSA 20-Li A1 GB
│
MT
│
21 ■
Safety guidelines for battery
chargers
■
This appliance may be used by
children aged 8 years and above
and by persons with limited
physical, sensory or mental
capabilities or lack of experience
and knowledge, provided that
they are under supervision or
have been told how to use the
appliance safely and are aware
of the potential risks. Do not al-
low children to use the appliance
as a plaything. Cleaning and
user maintenance tasks may not
be carried out by children unless
they are supervised.
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for
indoor use only.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3.
♦ A current list of battery compatibility can
be found at www.Lidl.de/Akku.
Working procedures
Viscosity
This appliance can process spray materials up to
max. 70 DIN/sec (viscosity). You can determine
the viscosity (thickness) of the substance with the
supplied measuring cup using a simplified
measuring procedure.
♦ Fill the supplied measuring cup to the brim
with the spray material.
♦ Remove the measuring cup from the spray
material and allow the liquid to run out.
♦ Measure the time (in seconds) until the stream
of liquid stops. This time is called "DIN seconds
(DIN/sec)".
♦ If the value is too high, gradually thin the spray
material by adding small amounts of a suitable
thinning agent and mixing the liquid.
♦ Measure the DIN seconds again. Repeat the
process until you measure a viscosity of less
than 70 DIN/sec.
NOTE
► Do not exceed the maximal viscosity of the
appliance. The spray material must not be
too thick. Otherwise, the appliance might
clog.
► Ensure that the spray material and thinning
agent are compatible. Using an unsuitable
thinning agent may cause clots that clog
the appliance. Never mix synthetic resin
varnishes with cellulose thinners.
► To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material.
► Granular products and products containing
solids must not be sprayed. Their abrasive
effect shortens the service life of the
appliance.