Quick Guide
FastFinish Pro Texture Sprayer
For Water-Based Materials Only.
3A7016A - EN
NOTICE:
Do not store spray system under pressure. This may cause damage to the spray system. Do not
allow material to dry inside hopper, hose, gun nozzles or spray system. This may cause system to fail.
Step 1:
Check material nozzle before spraying to ensure there is not an air blockage.
Step 2:
Make sure
hopper air passageway and air supply tube are free of debris. Clean before using.
Step 3:
Connect one end
of air hose to the compressor air outlet fitting and the other end to the gun air inlet fitting.
Step 4:
Test gun
trigger. Lubricate needle seals if necessary.
Step 5:
Install material nozzle on front of gun and secure using
retaining ring. Pulling the trigger when installing nozzle makes assembly easier.
Step 6:
If using WideTex
adapter, install disc (2) on front of adapter (3) with retaining ring (1). Install a standard nozzle (4) on front of
gun with the assembly. Pulling trigger when installing nozzle makes assembly easier. If desired finish is not
achieved, try a different size standard nozzle.
Step 7:
Plug power cord into a properly grounded outlet.
Read Operation manual 3A5725 for complete instructions and warnings.
Manuals are available by calling Graco at 1-800-690-2894, or at
www.graco.com
.
For Technical Assistance call 1.800.543.0339
This Quick Guide is not a substitute for reading and understanding all operation manuals
and warning labels supplied with the equipment. It is important that you read and
understand all warnings and instructions before operating this equipment.
Follow the pressure relief procedure and wear protective equipment including but not
limited to protective eye wear.
FAILURE TO FOLLOW ALL WARNINGS CAN RESULT IN SERIOUS INJURY.
SETUP
