Parkside 273460, Перевод оригинальной инструкции

Страница: 46 / 204

46
GB IE
Before putting into
operation
• The machine must be set up on a sta-
ble surface, i.e. on the base or similar
item. For this, use the drill holes which
are located in the frame of the machi-
ne. For safe use on a work bench, four
mounted rubber feet are provided
(ig. 5).
• Before the machine is put into operati-
on, all covers and safety devices must
be properly attached.
• The saw blade must be able to move
freely.
• In the case of wood which has already
been worked with, check for foreign
bodies such as nails or screws etc.
• Before pressing the on/off switch,
make sure that the saw blade is cor-
rectly attached and that moving parts
are free-running.
• Before connecting the machine, check
that the data on the type plate matches
those of the mains system.
• The machine must only be connected
to a properly installed safety socket
which is protected by a fuse of at least
16A.
• If possible, connect the device only to
a socket with a residual current circuit
breaker (RCCB) with a tripping current
of not more than 30 mA.
Operation
Switching on and off
(Figure 23)
- The saw can be switched on by
pressing the green pushbutton „I“.
Before you start sawing, wait until the
saw blade has reached its maximum
speed.
Attaching/changing the
Saw Blade
(Figure 22)
1. Caution! Remove the mains
plug and wear protective
gloves.
2. Dismantle the saw blade guard (2).
3. Remove the table insert (6) by relea-
sing the three countersunk screws (29)
(see Figure 17)
4. Place the hexagon socket key (s) (HX
6) on the bolt and use the jaw spanner
(t) (SW 22) to stop the motor spindle
from turning (see Figure 22).
5. Caution! Turn the bolt in the direction
of rotation of the saw blade.
6. Remove the outer lange and take the
old saw blade off the inner lange by
pulling downwards and diagonally.
7. Clean the saw blade langes carefully
with a wire brush before attaching the
new saw blade.
8. Insert and tighten the new saw blade
in reverse order.
Caution! Note the direction of
motion; the slope of the cutting
edge of the teeth must face the
direction of motion, i.e. for-
wards (see the arrow on the
saw blade guard (2).
9. Reattach and adjust the table insert (6)
and the saw blade guard (2).
10. Before you work with the saw again,
a check must be carried out to ensure
that the protective devices are working
properly.