Parklands PZT-42, Руководство оператора

Страница: 29 / 34

- 25 -
Problem
Problem Problem
Problem Possible
Possible Possible
Possible Cause
Cause Cause
Cause Corrective
Corrective Corrective
Corrective Action
Action Action
Action
Engine
will not
start,
starts
hard,or
fails to
keep running
1.Fuel tank is empty.
2.Oil level in the crankcase
is low.
3.The throttle and choke
are not in the correct
position.
4.Dirt in fuel filter.
5.Dirt, water, or stale fuel
is in the fuel system.
6.Air cleaner is dirty.
7.Seat switch is not
functioning properly.
8.Electrical connections are
corroded, loose or faulty.
9.Relay or switch is
defective.
10.Faulty spark plug.
11.Spark plug wire is not
connected.
12.Faulty module.
1.Fill the fuel tank.
2.Add oil to the crankcase.
3.Be sure the throttle control is midway
between the “SLOW” and
“FAST”positions, and the choke is in the
“ON”position for a cold engine or the
“OFF”position for a warm engine.
4.Replace the fuel filter.
5.Contact an Authorized Service Dealer.
6.Clean or replace the air cleaner
element.
7.Check the seat switch indicator.
Replace seat if needed.
8.Check the electrical connections for
good contact. Clean connector terminals
thoroughly with electrical contact
cleaner,apply dielectric grease and
reconnect.
9. Contact an Authorized Service Dealer.
10. Clean, adjust or replace spark plug.
11. Check the spark plug wire
connection.
12. Replace module.
Engine
loses
power
1.Engine load is excessive
2.Air cleaner is dirty.
3.Oil level in the crankcase
is low.
4.Cooling fins and air
passages for the engine are
plugged.
5.Dirt in fuel filter.
6.Dirt, water, or stale fuel
is in the fuel system.
1.Reduce the g round speed.
2.Clean
or replace the air cleaner
element.
3.Add oil to the crankcase.
4.Remove the obstructions from the
cooling fins and air passages.
5.Replace the fuel filter.
6.Contact an Authorized Service Dealer.
Machine
does not
drive
1.Drive or pump belt is
worn, loose or broken.
2.Drive or pump belt is off
a pulley.
3.Broken or missing idler
spring.
1.Change the belt.
2.Change the belt.
3.Replace the spring.