Parklands PZT-42, Руководство оператора

Страница: 26 / 34

- 22 -
MEASURE
MEASURE
Figure 17
Level Surface
7.2.6
7.2.6 7.2.6
7.2.6
Position right blade in the side to
side position and measure from the outside
blade tip to the level surface.
7.2.7
7.2.7 7.2.7
7.2.7
If the difference between both
measurements is greater than 3mm,
adjustment is necessary.
7.2.8
7.2.8 7.2.8
7.2.8
Locate the level adjust bolt (A) on
the left front mower deck hanger (Refer to
Fig.18).
A
B
C
Figure 18
7.2.9
7.2.9
7.2.9 7.2.9 Slightly loosen the chain bolt (C) on
the left front mower deck hanger and level
adjust bracket (B).
7.2.10
7.2.10
7.2.10 7.2.10 Adjust the left front of the mower
deck up or down as required to match the
right front by turning the level adjust
bolt(A)
clockwise to raise and
counter-clockwise to lower.
7.2.11 7.2.11 7.2.11 7.2.11 Adjust the level adjust bolt (A) until
blades on both sides are the same height
above the level surface.
7.2.12 7.2.12 7.2.12 7.2.12 With blades leveled side to side,
tighten the chain bolt (C )))) securely.
7.3. 7.3. 7.3. 7.3. Deck Deck Deck Deck Belt Belt Belt Belt Adjustment Adjustment Adjustment Adjustment
The belt tension is set at the factory, but
may need adjustment after the first hour of
initial use. Periodically belt should be
checked for proper tension, following the
procedure below(Refer to Figure 19).
7.3.1 7.3.1 7.3.1 7.3.1 Position the mower deck in the
lowest (1inch) cut height setting and
remove the left belt shield.
7.3.2 7.3.2 7.3.2 7.3.2 Loosen the lock nut (A) and adjust
the draw nut (C) to change belt tension.
11cm
C
B
A
Figure 19
7.3.3 7.3.3 7.3.3 7.3.3 Increase belt tension by turning the
draw nut (C) clockwise and decrease belt
tension
by turning the draw nut
counterclockwise(Refer to Fig. 19).
7.3.4 7.3.4 7.3.4 7.3.4 The idler spring (B) body length
should measure approximately 10cm for
proper belt tension.
7.3.5
7.3.5 7.3.5
7.3.5
Tighten the lock nut (A) when the
proper belt tension is achieved.
7.4.
7.4.
7.4. 7.4. D
D
D Dump
ump
ump ump Drive
Drive
Drive Drive Belt
Belt
Belt Belt Adjustment
Adjustment
Adjustment Adjustment....
Figure 20
B
A
C
11cm