Parklands PZT-42, Руководство оператора

Страница: 27 / 34

- 23 -
The way is similar to the above of Deck
Belt Adjustment ,The idler spring (B) body
length should measure approximately 10cm
inches for proper belt tension(Refer to
Figure 20).
7.5.
7.5. 7.5.
7.5. Neutral
Neutral Neutral
Neutral A
A A
Adjustment.
djustment. djustment.
djustment.
If drive wheels travel forward or backward
when the steering lever is in their neutral
lock position, adjustment is required.
7.5.1
7.5.1 7.5.1
7.5.1
Lift and support the rear of machine
using jack stands or other equivalent safety
blocks. DO NOT rely solely on mechanical
or hydraulic jacks or lifts for support.
Make
Make Make
Make sure
sure sure
sure
two drive wheels keep away
from the ground.
A
Figure 21
7.5.2
7.5.2 7.5.2
7.5.2 Start the engine and put the steering
levers in their neutral lock position of
operation,then observe which drive wheel is
rotating.That side will need to be adjusted.
7.5.3
7.5.3
7.5.3 7.5.3 If the left wheel need to be
adjusted, locate the position A(Refer to
Figure 21) ,the more detail of the position A
is shown as the Figure 22.
7.5.4
7.5.4
7.5.4 7.5.4 If the right wheel rotates clockwise
(From the outside view see Figure 21),
sightly loosen the nut(B and C),then turn the
neutral
buckle (A of Figure 21)
counterclockwise(from the direction of
arrow ,see Figure 21) until the wheel does
not rotate.On the other hand,turn the nut
clockwise. At last,tighten the nut(B and C)
securely.
7.5.5 7.5.5 7.5.5 7.5.5 If the left wheel needs to be
adjusted,use the same way to adjust the left
wheel.
A
Figure 21
C
B
7.6.
7.6. 7.6.
7.6. Seat
Seat Seat
Seat Adjustment.
Adjustment. Adjustment.
Adjustment.
A
Figure 22
Refer to Figure 22.The seat can be adjusted
forward and backward. Pull the adjustment
lever(A)
outward,position the seat as
desired,and release the lever to lock the seat
into position.
7.7.
7.7. 7.7.
7.7. Parking
Parking Parking
Parking Brake
Brake Brake
Brake Adjustment
Adjustment Adjustment
Adjustment
7.7.1 7.7.1 7.7.1 7.7.1 Disengage the PTO, stop the engine,
block the front wheels, remove the ignition
key, and engage the parking brake.
7.7.2 7.7.2 7.7.2 7.7.2 Locate the brake spring (A, Figure
23).
7.7.3 7.7.3 7.7.3 7.7.3 With the parking brake engaged,
measure the stretched spring length. The
spring should be 64~68mm when
stretched.