Parker Zander WVM 40, Руководство по эксплуатации

Страница: 46 / 56

EN | Operating manual Maintenance and repair of the dryer
46 WVM 40 -1450
Remove spent desiccant
Release pressure from dryer and shut down the unit (see page 37).
Place suitable container below the discharge sleeve.
Remove the plug at the sleeve, using a
suitable tool.
Collect desiccant in the container positioned
below the sleeve.
Remove any desiccant left in the vessel
by using an industrial vacuum cleaner at the
sleeve. This procedure also cleans the screen
base and removes any residual material and
deposits.
Equip the sleeve plug with a non-locking
thread seal and screw in. Check thread seal and
replace, if necessary.
Removing plug from fi ller sleeve
Repeat the procedure for the second vessel.
Caution!
If the dryer has been improperly operated, the desiccant might be contami-
nated with pollutants. Please take this into account when disposing of the
desiccant.
Notes on the disposal of used desiccant
As the used desiccant is contaminated with various substances, its properties differ from
those of new desiccant. For this reason, the manufacturer or supplier of desiccant cannot
give any information on the used product.
Deliver used desiccant to a controlled dumping while heeding local offi cial regulations.
Waste codes
◊ Unused product: 060899 (European waste code).
◊ Used product: These codes are governed by the industrial use and must therefore be deter-
mined by the waste originator.
Filling vessel with new desiccant
Risk of falling!
Do not use the dryer as a climbing aid. The components are not designed to
bear such a load and may break.
Only use approved climbing aids when fi lling the vessel.
Note:
Filling can also occur via the main line socket. This is feasible if the desiccant
sieve is also cleaned or replaced (see page 44).