Parker Zander WVM 40, Руководство по эксплуатации

Страница: 30 / 56

EN | Operating manual Start-up
30 WVM 40 -1450
Start-up
Warning!
The dryer must be taken into operation by trained personnel only! Untrained
personnel does not have the required knowledge. Such personnel might cause
serious faults.
Note:
You can order the initial commissioning and start-up from the manufacturer
and have your personnel trained by the manufacturer. For telephone number,
see page 6.
◊ Carry out all prescribed tests and checks.
◊ Before start-up, ensure that no tools or other foreign parts have been left lying in a part of
the dryer where they might pose a hazard to the dryer being started up.
Requirements for initial commissioning
The following conditions must be met for initial commissioning:
◊ All pipelines are free of contamination.
◊ All shut-off valves are closed.
◊ The dryer has been properly set up, wired and connected.
◊ The compressors are ready for operation.
◊ At the outlet side, a compressed air consumer is present, i.e. compressed air can fl ow
through the dryer.
◊ Operators for the components are available.
Inspection to be carried out prior to commissioning
◊ all pipe, cable and screw connections have been retightened,
◊ none of the lines are worn at edge of the dryer body,
◊ all connections are properly secured,
◊ the electric connections are properly secured and in good condition,
◊ the operator-supplied components such as safety valves and other equipment holding
pressure are not blocked by dirt or paint,
◊ all components of the compressed air system that are under pressure (valves, hoses, etc.)
are free of wear or other defects,
◊ suffi cient amounts of required supply media such as steam or cooling water are available at
suitable quality and the respective shut-off valves are open.
Overview of the operating and display elements
The operating panel at the switch cabinet door allows for the monitoring of the operating sta-
tuses and for the modifi cation of settings. The display is a Touch Screen Panel. To operate,
touch the elements on the screen.
For further information on the operating panel and the controller’s functions, please refer to
the enclosed controller manual.