XPR2/XPC2 PowerStation Series Hardware User Guide
Page 14 of 47
8” XPR2/XPC2 PowerStation Mounting Procedures
To install an 8” PowerStation, complete the instructions below:
1) Create a rectangular cutout in the user’s enclosure according to the 8” XPR2/XPC2 mounting
drawing located on the XPR2/XPC2 Utilities, Drivers & Documentation CD supplied with unit.
2) Slide the PowerStation into the cutout from the front side of the enclosure.
3) Assemble the 4 mounting clamps with their screws as shown:
4) Attach the 4 mounting clamps, with their screws, to the back of the unit in the slots provided. Place
2 clamps at the top and bottom:
5) Insert the clamp into the wide end of the slot and slide it to the thin end.
6) Tighten each of the mounting screws against the front of the enclosure.
7) Torque the screws until the gasket is compressed by 50%.
Caution
—
Do not over-tighten the screw/clamp assembly or you may
damage the PowerStation. However, under-tightening may not guarantee a
Type 4X Indoor Use Only or Type 12 rating.
8) Tighten the screws in a crosswise sequence to ensure a good seal and prevent damage.
Note that properly tightening the clamps may not result in a gasket seal that is totally depressed by the
bezel and flush with the enclosure. Since a proper Type 4X Indoor Use Only or Type 12 rating requires
a 50% compression of the gasket, you may see a small gap between the bezel and the enclosure.
Slide
clamps
into
slots
–
4
locations