29
05
101
P1 side
1/8" hex
wrench
Assembly
5
. Install P1 and P2 lock nuts (05) onto shaft (02)
and tighten snug.
6
. Using a pin spanner wrench or two metal dowels
and a pry bar, tighten the P1 lock nut (5)
to 120 ft-lbs (162 Nm). Then loosen the lock nut
just far enough until the two retainer pin (105)
holes line up.
7
. Install the two retainer pins (105) and the five
fitting plugs (101) into the lock nut (05) on the P1
side.
8.
Using a pin spanner wrench or two metal dowels
and a pry bar, tighten the P2 lock nut (5) to
120 ft-lbs (162 Nm). Without over tightening,
adjust the lock nut as needed to insert the two
remaining retainer pins (105). Install and tighten
the five fitting plugs (101) into the lock nut (05).
9.
Remove the three tabs installed to secure the
jaw to the bucket shell prior to disassembly.
05
05
04
05
101
105
P1 side
P1 side
#8-32 x 1.00"
machine
screw
pin
spanner
wrench
retainer pin
(105) hole
A
C
B
ASSEMBLY
