28
Assembly
1
. Install the piston sleeve (03) into the housing
(1) from the P2 side, engage the teeth and
push in until the measured distance from the
back of the piston sleeve (03) to outer edge of
the housing bore at the P2 side is as recorded
during step five of disassembly on page 21.
2
. Install the shaft (02) in the P1 side and position
it inside the housing (01) until it is even on both
P1 and P2 sides, while keeping the piston (03)
to housing bore distance unchanged. Confirm
piston (03) to housing distance and adjust as
needed while maintaining shaft (02) position.
3
. Coat the drive hub ID splines with nickel anti-
seize (Loctite 77169 or equivalent). Install drive
hubs (04). If OD splines do not align with jaw
splines, remove hub and index the hub until
both ID and OD splines align.
4
. Coat the lock nut (05) threads, OD, and flange
mating surface with nickel anti-seize (Loctite
77169 or equivalent).
NOTICE
Lightly oil inside the housing and
each component as installed.
NOTICE
Proper piston sleeve position
ensures that the bucket will close
before the piston sleeve reaches
it’s internal stop. If improperly
positioned, the piston sleeve will
bottom out against the ring gear
causing damage to the gear teeth.
P2 side
01
01
03
03
01
03
02
01
04
ASSEMBLY
