23
Disassembly
6
. Using a plastic mallet, drive the shaft (02) toward
the P1 end until the shaft protrudes far enough
to grasp. Carefully pull the shaft (02) out from
the P1 side of the actuator.
8
. Some models have seals on the ID and / or OD
of the lock nuts (05). If they exist, remove the
seals and back-up rings from both lock nuts
using a seal tool.
9
. Remove the bearings (341, 343) from both drive
hubs (04).
7
. Using a plastic drift and plastic mallet, carefully
drive the piston sleeve (03) out the P2 port side
of the actuator housing (01).
02
230
05
231
02
03
01
NOTICE
Be sure the piston sleeve (03) and
housing (01) are not damaged
during disassembly.
NOTICE
As seals are removed, note their
orientation. Many seals work in
one direction only.
DISASSEMBLY
To avoid damage to the
gear teeth and housing
bore:
Carefully support the weight of the shaft as
it clears the piston sleeve.
