Parker PEPW-2000, Руководство пользователя

Страница: 19 / 22

36 37
TROUBLESHOOTING
MAINTENANCE
CLEAN - UP AND STORAGE
SHUTTING DOWN AND STORING THE PRESSURE WASHER
•
Turn the pressure cleaner to the OFF(0) position.
•
Turn off the water supply.
•
Before disconnecting high-pressure hose connection, point the gun
in a safe direction and discharge the high-pressure water.
•
Disconnect high-pressure hose from the pressure cleaner and gun.
•
Disconnect garden hose from the pressure washer.
•
Remove quick coupler fitting from garden hose and attach to the
nipple portion of the fitting installed on the pressure cleaner for
storage.
•
Remove excess water from the pump by tipping the unit on both
sides to drain any remaining water from inlet and outlet fittings.
•
Remove Water Intake and flush with water to remove dirt or debris.
Return filter once cleaned.
•
Drain detergent reservoir and flush with running water.
•
Wipe away any remaining water on all parts and fittings.
•
Engage the gun safety lock.
•
Store the pressure washer, parts, and accessories in an area with a
temperature above 0 C (32 F).
WINTERIZING AND LONG-TERM STORAGE
Follow all of the above shut-down procedures, adding the following
steps:-
•
After disconnecting the water supply, and before disconnecting the
high-pressure hose, turn the pressure cleaner on for 2-3 seconds,
until any remaining water in the pump exits.
WARNING - DO NOT run the machine for too long. Continued use of
the pressure washer without water supply attached will cause severe
damage to the unit!
•
Always store the pressure cleaner, parts, and accessories in an area
with a temperature above 0° C (32° F).
WARNING - Failure to comply with these storage instructions will result
in damage to the pump assembly.
MAINTENANCE
WARNING!
Before performing any maintenance on this machine, turn the power
switch to Off(0) and unplug from the mains.
•
This pressure washer is supplied with a closed lubrication system, so
no addition of oil is needed.
•
Check all hoses and accessories for damage prior to use.
•
Check the water inlet periodically for deposits. Clean this regularly for
maximum performance.
i
i
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Machine will not start when power
switch is in the 'On(I)' position
Power socket is faulty Check plug, socket, fuses.
Voltage is inadequate Check whether the voltage is adequate
Power cord is not plugged in. Plug power cord in.
Pump does not reach adequate
pressure / Power fluctuates
Water inlet is clogged. Remove and clean inlet.
Pump is drawing air. Tighten connections / bleed system
Suction valves are clogged/worn. Clean or replace valves.
Diameter of garden hose is too small. replace with 3/4 inch garden hose.
Water supply is restricted. Check hose for kinks or leaks.
Insufficient water supply
.
Fully open water source.
Will not maintain pressure Excessive air in waterline and pump. Turn unit and water supply off / Bleed system / Hold trigger down..
Excessive noise
Intake is blocked. Check intake valves.
Valves are worn, dirty or clogged. Check, clean or replace valves
Filter is dirty. Check, clean or replace filter
Machine cuts out during use Net voltage lower than suggested. Check whether the voltage is adequate.