Parker HLR070, Инструкция по монтажу

Страница: 9 / 56

Parker EME For Safety Use
192-510201N1 HLR 2019-04
9

Persons who have a knowledge of first-aid techniques and the local emergency
rescue services.

Persons who have read and will observe the safety instructions.
Instructions for Special Hazards
The linear module must be fixed or supported in accordance with the indications
in this manual.
The operator must ensure that operation of the linear module does not cause any
danger.
If the linear module moves in hazardous areas, these areas must be safeguarded
with safety transmitter switches.
1.5.4. Safety Instructions for the Company Using the System
Supervisors must also become familiar with the entire chapter entitled "Safety"
and handling required on the linear actuator.
Supervisors must ensure that installation and operating personnel have read and
understand the chapter entitled "Safety" and the description of how to work with
the machine, and that they observe the instructions.
The manual must be available close to the linear module during the performance
of all tasks.
It is impermissible to operate the liner module if it is not in perfectly functional
condition.
Depending on the application, the operating company must provide for a suitable
separating safety fence. Access to the motion range during operation must be
prevented.
The user must make sure that the work area is protected by appropriate safety
devices.
1.5.5. Safety Instructions for Operating Personnel
Any work step that has a negative effect on the operating safety of the linear
motor module must be omitted.
Operating and supervisory personnel are required to check the linear actuator or
machine at least once per shift for externally visible damage or defects. Changes
that have occurred (including the operating behavior) that could have a negative
effect on the operating safety must be reported immediately.
Components and accessories are designed especially for this product. When
purchasing spare and wear parts, use only original Parker parts. We explicitly
draw your attention to the fact that we are unable to check or release spare parts
or accessories that were not provided by us. Installing and/or using such products
may cause negative changes in the required design properties in some
circumstances, which in turn could negatively effect the active and/or passive
operating safety of the product.
The manufacturer is unable to accept any liability for damage caused by using
non-original parts and accessories.
Depending on the operating conditions (rotation speed, load, etc.) increased
surface temperature in the area of the drive may occur. When touching it during
operation slight injuries from burning may occur. Don't touch the product during
operation. At maintenance, service and repair always take care that the product is
cooled off before starting work.
Safety and protection devices are strictly NOT to be removed or bypassed or set
out of order.
Applicable requirements and national accident prevention regulations must
always be observed when installing and operating our linear motor module.