Parker HLR070, Инструкция по монтажу

Страница: 48 / 56

Maintenance and service HLR Mounting Instruction
48
192-510201N1 HLR 2019-04

Insert the replacement toothed belt (Figure 15, Pos. 3) into the upper opening of
one of the return stations and push the toothed belt around the toothed pulley
(Figure 15, Pos. 4) . In order to facilitate installation, turn pulley in pushing
direction.

Push in the toothed belt further until the toothed belt runs through the profile and
runs around the toothed pulley in the opposite deflection station. In order to
facilitate installation process, turn pulley of the opposite deflection station in
pushing direction.

Pull the toothed belt out of the opposite deflection station and place both ends of
the toothed belt on the carriage.

Insert one toothed belt end into the toothed belt tensioning element (Figure 15,
Pos. 2) and screw it in on one side of the carriage.
The toothed belt must fit into all teeth of the belt tensioning element.

Insert the second toothed belt end into the belt tensioning element, insert it on the
other side of the carriage and adjust the toothed belt tension to the "standard belt
pre-tension of new belts” (see page 45) with the tensioning screw, see Table 14).
After the toothed belt tension has been correctly adjusted, the steel strip sliding
rods, steel strip deflections, steel strip cover, carriage lid (see page 43) and drive
(see page 27) can be reassembled.