412LXR Series Product Manual
Chapter 6 - Maintenance and Lubrication
39
•
Remove the M3 Button Head Cap Screws that attach the
side covers to the base.
•
Slide the side cover off the base.
•
The base mounting holes can now be accessed.
•
Great care should be used when inserting and tightening
screws on the side with the encoder tape scale. If the
tape is damaged the linear encoder will not function
properly and the table may “run away.”
Reassemble positioner by reversing steps.
Note: When installing the strip seals to the unit, completely
tighten one clamp while the leaving the other side loose.
Thread, but do not tighten the screws on the other end. Pull the
clamp away from the carriage and tighten the screws to ensure
the strip seal is pulled taught.
