404/406XR Series Product Manual
Chapter 1 - Introduction
6
Parker Hannifin Corporation
1140 Sandy Hill Road
Irwin, PA 15642
www.parkermotion.com
Return Information
Returns
All returns must reference a “
R
eturn
M
aterial
A
uthorization”,
(RMA)
, number. Please call your local
authorized distributor or Parker Hannifin Corporation Customer Service Department at 800-245-6903 to
obtain a “RMA” number. See Parker Hannifin Corporation Catalog #8080/USA, page D34, for additional
information on returns and warranty.
Repair Information
Out-of-Warranty Repair
Our Customer Service Department repairs Out-of-Warranty products. All returns must reference a
“RMA” number. Please call your local authorized distributor or Parker Hannifin Corporation Customer
Service Department at 800-245-
6903 to obtain a “RMA” number. You will be notified of any cost prior to
making the repair.
Warnings and Precautions
Vertical Operation
Depending upon your load and ballscrew selection the carriage and load may ‘backdrive’ in power loss
situations potentially causing product damage or personal injury. An electro-mechanical brake, which
will activate in response to a loss of power (option ‘B2’), can be used to prevent potential product
damage or personal injury.
Strain Relieve Electrical Components
All electrical components (such as brakes, encoders, and limit/home switches) must be strain relieved.
Failure to strain relieve electrical wires or cables may result in component failure and/or possible
personal injury.
Specification Conditions and Conversions
Specifications are Temperature Dependent
Catalog Specifications are obtained and measured at 20 Degrees C. Specifications at any other
temperature may
deviate
from catalog specifications. Minimum to Maximum continuous operating
temperature range
(with NO guarantee of any specification except motion) of a standard unit before
failure is 5 - 70 Degrees C. Certain components can be eliminated or substituted to improve operation at
these temperatures. Positioners with low temperature or high temperature components will be handled
as specials, contact your local distributor.
Specifications are Mounting Surface Dependent
Catalog Specifications are obtained and measured when the positioner is
fully supported
,
bolted down
(to eliminate any extrusion deviation), and is mounted to a work surface that has a
maximum flatness
error
of 0
.013mm/300mm (0.0005”/ft).
Specifications are Point of Measurement Dependent
Catalog Specifications and Specifications in this manual are measured in the center of the carriage,
37.5mm above the carriage surface. All measurements taken at any other location may deviate from
these values.
www.comoso.com
