English
33
Cutting head is hard to
turn
Grass wrapped or built up
around head.
Clean affected parts of the machine.
Grass wraps around the
attachment shaft and the
trimmer head assembly
Cutting tall grass at ground level. Cut tall grass from the top down.
Trimmer stops and will not
start again
1) Overload protection activated
2) Unit failed
3) Plug is damaged.
1) Wait 10 minutes before restarting
2) Contact dealer to check damage
3) Check the plug
6.Maintenance and Cleaning
Caution. Use only mild soap and a damp cloth to clean the tool.
Never allow any liquid to get inside the tool, never immerse any part of the tool into a liquid.
Caution. Never hang edger on the switch trigger or power cord.
Preventing Corrosion
Fertilizers and other garden chemicals contain agents that greatly accelerate the corrosion of metals. If you
use the tool in areas where fertilizer or chemicals have been used, the tool should be cleaned immediately
afterwards. Wipe all exposed parts with a damp cloth. You may lubricate only metal parts with a light
petroleum based oil. When cleaning never immerse in water or squirt it with a hose.
General inspection
1. Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Repairs
1. Only an authorized service center should replace the cord set or affect other repairs. If the cord set is
damaged or worn, have it repaired or replaced by on authorized service center.
7.Customer Assistance
Please contact the place of purchase stated on the invoice.
8. Guarantee
In case of complaint, please present the product or defect part, to the place of purchase.
We guarantee the product in accordance with statutory/country specific regulations, proof of purchase by
invoice.
Damage due to normal wear and tear, overload or improper handling will not covered by the guarantee.
