Pari eFlow rapid, Инструкция по эксплуатации

Страница: 27 / 282

eFlow
®
rapid - 2021-04 23
en
Fault Possible cause/Remedy
The controller cannot be switched on
(no beep, no orange or green light
signal). - To switch on, press the ON/OFF button
for approx. 2 seconds.
- Is power plug plugged into mains and
the device (for mains operation)?
- Are batteries inserted correctly?
- Check the charge level of the batteries.
After switching the controller on, no
aerosol is generated, and/or the
controller switches off again after
a few seconds. - Has the medication reservoir been filled
with medication?
- Check the connection between the
controller and the nebuliser handset.
The controller switches off even
though there is still medication left in
the medication reservoir. If there is still more than 1 ml in the
medication reservoir of the eFlow
®
rapid
nebuliser handset:
- Check the charge level of the batteries.
- Was the nebuliser handset held
horizontally throughout the inhalation
session? Hold the nebuliser handset
horizontally.
- The controller switches off
automatically after 20 minutes.
Carry out inhalation to the end by press-
ing the ON/OFF button again, so that
you can inhale the prescribed dose of
medication.
If the maximum operating time for each
inhalation session is exceeded
repeatedly, the aerosol head must be
replaced.
Info:
Note that about 1 ml of medica-
tion cannot be nebulised and
remains unused in the medica-
tion reservoir of the
eFlow
®
rapid nebuliser handset;
this residue must be discarded.
This is intentional and does not
represent a malfunction.
With medication-specific nebu-
liser handsets (
Tolero
®
, Zirela
®
and Altera
®
) there is no signifi-
cant volume of residue left in
the medication reservoir.
The controller does not switch off
automatically even when no more
aerosol is being produced and there
is no more than about 1 ml of residue
left in the medication reservoir of the
eFlow
®
rapid nebuliser handset.
The treatment session has been com-
pleted successfully and the controller can
be switched off by pressing the ON/OFF
button.