9
VENT TUBE WARNING LABELS
(Figures 8 and 9)
Included in each MDX² are two warning labels that need
to be placed on the pool equipment if the pool is to be
winterized and has a vent tube on any of the drains
plumbed on the pool. Attach the smaller label to the vent
pipe where it terminates to atmosphere.
(See Fig. 8)
Attach the larger label to the control panel next to the
controller for the pump with the vent tube plumbed to it.
(See Fig. 9)
1.
Remove outer lid, inner lid and basket, clean and
dry off, and store in same area as modules
2.
Install and secure regular winterization plug in
equalizer line of canister to pool at poolside.
3.
Install and secure Schrader plug or blow out plug
from canister to main drain. Blow out and obtain air
lock as previously described, if skimmer is tied into
canister, repeat procedure to skimmer.
4.
Bottom port of canister to pump may require an
extended pipe for ease of blowing out. Install and
blow out line from canister to pump. Install and
secure plug in pump. Using shop vac, remove all
water from within canister components.
5.
Extension pipe can be removed and replaced with
plug or Gizmo type container if Gizmo not used. Be
sure to install device to absorb ice expansion in
canister area. Failure to do this may result in
potential ice freeze damage to canister.
PARAMOUNT CANISTER WINTERIZATION
TEST PLUGS
2" GALV.
SQ. HEAD
BALANCE LINE
TO MAIN
DRAIN
TO OPTIONAL SKIMMER
OR VENT LINE
USE STANDARD
SKIMMER PLUG
WRENCH
Winterization anti-freeze is to be used as necessary or
when required.
Additional questions should be forwarded to
Paramount's corporate office at 800.621.5886.
For technical assistance call 1-800-621-5886 or contact your regional representative.
