REMOTE CONTROL
6
* Remote control requires 2 AAA batteries not included.
A master button is located on the bottom right hand side of the insert. This button must be turned ‘On’
(indicator light will illuminate) to operate remote control. Turn button to ‘off’ to disable the use of the
remote control. Once the remote control button is turned ‘on’, all of the functions are the same as on
the control panel listed on the previous page.
FLAME EFFECT/LIGHT BULB REPLACEMENT
Allow the electric fireplace insert to cool before attempting to replace light bulbs. The flame effect on
this electric fireplace insert is created by illuminating (2) clear 120V, 40 watt E-12 (small base,
chandelier candle type) light bulbs. The life of the light bulbs will depend on how often the fireplace is
used. Do not use light bulbs that exceed 40 watts per bulb.
1. Turn power to off and unplug insert from electrical outlet before changing light bulbs.
2. Slide fireplace mantel away from wall to gain access to back of fireplace.
3. Locate access panel on back of insert.
4. Using a Phillips screwdriver, remove screws in access panel. Open door and replace
light bulbs as necessary. It is recommended that both light bulbs be replaced at the same time.
5. Follow steps 1 through 4 in reverse order to reinstall access panel.
NOTE: We do not supply replacement light bulbs. They can be purchased at many home
centers or hardware stores.
Fig. 3
Power
Heat Settings
Timer
Higher Flame Intensity
Lower Flame Intensity
