Paragon P7, Инструкция по установке и обслуживанию, Страница: 17 / 28

17 LT6757 ( Iss 1 06/14 )
P7 Installation Instructions
SECTION NINE To Install the Appliance continued
.

Position the loose magnet against the
inner return of the four sided trim
assembly.

Offer the trim up against the firebox,
with the top return of the trim rest upon
the top of the fire box flange.
P7 Installation Instructions
SECTION NINE To Install the Appliance Continued
CHECKING GAS SOUNDNESS AND RUNNING PRESSURE.

Turn on the gas supply to the appliance and check for soundness in accordance with current codes of practice.

Turn off the gas supply at the external Isolation valve.

Remove the pressure test point screw from the inlet elbow and connect the pressure gauge.

Turn on the gas to the appliance at the Isolation valve.

Light the appliance as described in section 2.

Check the inlet pressure is 20mbar. +/- 1.0

Turn off gas supply, at the isolation valve. Disconnect the pressure gauge and replace the pressure test point screw.

Turn on the supply to the appliance and check the pressure test point for soundness with detection fluid.

Refit the gas connection cover.

Fit the air tray within the location with the burner shelf.
LAY FUEL BED
Important: -
Refer to the ‘Heath & Safety Notice located on page 3 of this booklet before laying or replacing any refractory material.
In the event of replacing fuel bed components please use only the specified number of components as illustrated. Only
use fuel bed component provided for this appliance. In the interest of safety and efficiency of your appliance when
replacing the fuel bed it is essential that the existing fuel bed be removed and the new components are replaced correctly
as a complete set.
Lay fuel bed as described under Users Section.
Warning:
It is important that the fuel bed components are positioned as shown in these instructions.
If the fuel bed components are not positioned correctly this may result in damage to the glass.