Paragon P7, Инструкция по установке и обслуживанию, Страница: 15 / 28

15 LT6757 ( Iss 1 06/14 )
P7 Installation Instructions
SECTION EIGHT Siting the Appliance Continued
CHECKING THE FLUE AND FIRE OPENING

Check that the chimney conforms to the required specifications as previously stated. Examine the
condition and carry out any remedial work including removing any debris from the base.

If the flue has been used for solid fuel it should be swept prior to the installation

Prior to installing the appliance a smoke test (using a smoke bomb) should be carried out to check
that satisfactory smoke clearance has been established.
If all the smoke is not drawn into the flue, pre-heat the flue with a blowtorch or similar and re-
check. If there is any uncertainty examine for the cause and, if necessary, seek expert advice.
No combustible material should be fitted inside the fireplace opening.

When installing this appliance against a dry lined (plasterboard) wall ensure that any void
between the plasterboard and the wall is sealed with a suitable
non-combustible material (i.e. plaster or mortar).
GAS SUPPLY ROUTING
Use rigid or semi
– rigid tube to connect the supply. Determine the
gas supply pipe route to the appliance before installing the fire .
Fixing Firebox Assembly

Slide the firebox into the fireplace open
guiding the gas supply pipe through the hole
at the rear LH bottom of the firebox.

Retain the Firebox using wall plugs and screw
using the four holes within the firebox flange.

Refit the grommet over the pipe and seal
around the inlet hole.

Remove the gas connection cover located
within the burner

The flue outlet hood can now be fitted into the
top of the Firebox assembly and secured
using the M4 nuts provided.

Offer the glass canopy with the side liner cut
outs.

Canopy fixing bracket can now be fitted, secure the bracket using the three M4 studs position
within the fire box top.

Fit the canopy liners LH & RH and secure by bending down the finger folds with the canopy fixing
bracket.

Finally locate the Air tray assembly within the fire box shelf.

Lay the fuel bed as described in section four.