8
LT5052 (ISS 5)
LIGHTING THE FIRE
A.
Push the control knob in as far as possible on gas control.
B.
Turn knob anti-clockwise until a click is heard. The knob will stop at the position marked
and a spark
should be seen at the tip of the ignition probe. At the same time the pilot flame should light. KEEP THE KNOB
PRESSED IN FOR 20 SECONDS. Should the pilot fail to light, turn the control knob clockwise to the
position, wait 3 minutes, and repeat the procedure.
C.
After lighting the pilot flame the control knob should be allowed to spring out slightly. This will allow you to
turn the knob further anti-clockwise to the position marked . The pilot flame should then ignite the main
fire.
D.
It is possible to adjust the height of the flames by turning the control knob between the positions marked
and
. Note that the knob 'latches' in position at either end of this movement and must be pushed in
slightly before it can be turned.
NOTE:
During normal use the red light may illuminate indicating a flue restriction (this may be due to a flue obstruction or
adverse wind conditions). In these circumstances the fan speed will increase and if the condition is not corrected in
approximately 10 seconds the gas supply will be shut off. The control knob must be turned to the
position and the off switch
must be pressed to reset the control.
Before attempting to relight the fire wait 3 minutes.
TURNING OFF THE FIRE
A.
Depress the knob slightly and turn fully clockwise to the position.
B.
Turn the fan off by pressing the switch marked 'OFF'. The fan should always be turned off when the fire is
not in use.
SECTION THREE Cleaning (user instructions)
Warning: -
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
CLEANING: TRIM, FRET or FASCIA
Abrasive or chemical cleaner should
never
be used. The fret and trim may be cleaned with a clean damp cloth.
N.B The trim and fire fret should be removed for cleaning. (The trim is held in place by magnetic strips).
CLEANING: BLACK PAINTED SURFACES
