10
LT5052 (ISS 5)
Warning: -
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
Use only the fuel bed components provided, no additional parts must be added.
Incorrect positioning of the fuel bed components could result in the excessive black on some parts of the fuel
bed.
Important: - Refer to the Health & Safety Notice located on page 5 of this booklet
before cleaning or replacing
any refractory material.
The fuel bed components are delicate and they should be handled with great care.
The loose parts and moulded shapes may be removed for cleaning. They can be brushed very gently with a soft
brush to remove dust or any deposits.
A vacuum cleaner may only be used after the loose components and moulded shapes have been removed.
CARE SHOULD BE TAKEN TO AVOID CONTACT WITH THE REFRACTORY LININGS THEIR SURFACES ARE DELICATE AND
SHOULD
NOT
BE WIPED OR RUBBED.
It is important that all the fuel bed moulded shapes are positioned as shown in these instructions.
FUEL BED LAYOUT (COAL OPTION)
Ensure the BASE MATRIX is in position as shown. It
should be located against the rear edge of the burner
outlet.
