LT4548 (10:09/10)
16
FLOOR SURFACE
HEARTH SURFACE LINE
LINTEL SET
IN POSITION
CAVITY PACKED 100mm
DEEP W ITH ROCKW OOL
ALL FOUR SIDES
OUTER SKIN
OF W ALL
125mm CORE
DRILLED HOLES
CUT OUT IN W ALL FOR
CAVITY RECESSED
INSTALLATIONS
MARKING OUT WALL FOR
CAVITY RECESSED
INSTALLATIONS
FLOOR SURFACE
202 mm
202 mm
480 mm
POSITION
OF PILOT
HOLE
5 5 5 m
m
CENTRE LINE OF
INSTALLATION
105 mm
POSITION
OF PILOT
HOLE
MARK POSITION
OF LINTEL
HEARTH SURFACE LINE
OR BASE LINE FOR
HOLE IN WALL (50mm min. from floor)
PARAGON FOCUS RS
Installation Instructions
SECTION TEN
To Install the Appliance
INSTALLING THE APPLIANCE INTO CAVITY WALL
(
When installing in a timber framed
dwelling reference must be made to the specific installation requirements stated later in this
Section
„Installing The Appliance In Timber
Framed Dwelling‟
)
.
Ensure it is a suitable outside wall
constructed of non-combustible
materials and that the flue position
meets the requirements previously
described in
Section 8
.
Mark a horizontal line on the wall
at the intended hearth surface or
appliance base height (50mm min
for Hole in Wall installation (the
skirting board must be cut away from behind the fire).
Mark a vertical line on the wall at the intended centre of the appliance up from the horizontal line
for a height of 555mm.
Mark two more vertical lines 202mm either side of the centre line for a height of 555mm.
Mark a horizontal line at a height of 555mm above the hearth line, joining the two outside lines
together.
Mark the position for a lintel above the top horizontal line.
Mark two short horizontal lines so they cross the centre line, one at 105mm and the second at
480mm above hearth level line. These are the centre points for the air duct and flue holes.
Using a long masonry drill, make two pilot holes completely through the wall, ensure the holes are
drilled accurately at the centres and square to the wall both horizontally and vertically at the two
cross points previously marked.
Cut out the brickwork of the inner skin of the cavity wall for the lintel, and position and fix the lintel
with mortar.
Cut out the brickwork under the lintel, between the two outside vertical lines into the cavity.
Ensure the cut-out width is square, try the appliance into the opening.
Using 125mm (5”) core drill, cut two holes following the pilot holes, drill from the outside through
to the cavity.
Remove any cavity insulation from the
cut-out opening and for a further 100mm
into the cavity gap each side and above.
Pack “Rockwool” around the sides and
top of the opening into the cavity for a
depth of 100mm.
Lay the hearth if required so that it is
positioned correctly to the horizontal line.
Position and fix the back panel and
surround if required.
Offer the appliance into the opening and
mark through the gas pipe entry hole (see connecting the gas supply later in this manual).
Pass a tape measure through the core-drilled holes and record the distance from the back of the
spigots to the surface of the outside wall.
Содержание Focus RS
Страница 26: ...LT4548 10 09 10 26...
