Paragon Fires Focus RS, Руководство пользователя

Страница: 15 / 28

LT4548 (10:09/10)
15
25 50 75 100 125 150 175 200 225 0
750
800
850
900
950
1000
1025
EXAMPLE: 925 SHELF HEIGHT=165 MAX. SHELF WIDTH
"B" SHELF WIDTH
"A
"S
H
E
L
F
H
E
IG
H
T
F
R
O
M
H
E
A
R
T
H
all dimensions in mm's
PARAGON FOCUS RS Installation Instructions
SECTION EIGHT Siting the Appliance Continued

The back panel of the surround must
have a cut-out within the maximum and
minimum dimensions as shown.

Ensure that gas supply is suitably sited.

A non-combustible hearth must be
provided beneath the appliance if the
appliance is fitted at low level (less than
150mm from floor). The hearth must have
a minimum thickness of 12mm and the
perimeter 50mm above floor level. The
hearth must extend the full width of the
appliance and must project forward a
minimum of 100mm in front of the
appliance.

Alternatively the appliance may be fitted
without a hearth (Hole in the Wall type
installations), 50mm min. from the floor to the base of appliance

The minimum clearance from the hearth (base of appliance) to the underside of a combustible
shelf should be determined using the shelf chart.

Minimum width between vertical sides of
combustible surround should not be less
than 800 mm provided fire is central to the
surround and sides do not project more than
150 mm. When vertical side forward
projection is increased by 12.5 mm add 50
mm to inside width of surround.

Check with the supplier or manufacturer that
the surround meets 150
0
C minimum rating
(attention should especially be given to man
made materials such as resin).

When installing in a timber framed dwelling
reference must be made to the specific
installation requirements stated in
Section
10 Installing The Appliance In Timber
Framed Dwelling.
SECTION NINE Preparing the Appliance for Installation

Carefully unpack the appliance from the carton and check the contents.

Lift off the decorative trim, which is held by four magnets and put to one side.

Lift away the fascia grill unit, which hooks over the lip of the combustion chamber.

Lay the appliance on its back ensuring suitable protection is provided for the carpet / floor.

Remove the two cross head nuts securing the fret apron and remove the apron

Remove the crosshead nuts from the top and bottom glass panel clamps and lift away carefully
the both clamps.

With extreme care lift away the glass panel and put to one side in a safe place note the printing
and ensure it is placed so that it is fitted correctly.

Remove the refractory components from the inside of the appliance.

The appliance is now ready for installation.