Paragon Fires focus rs plus remote, Руководство пользователя

Страница: 7 / 28

LT5944 Iss 1 (25/10/11)
7
PARAGON FOCUS RS PLUS Users Instructions
SECTION FOUR Cleaning & Fuel Bed Laying Continued
Note: - If the fuel bed has not been placed correctly, causing the gas flame to contact the glass this
may result in glass staining that cannot be removed by cleaning.
Re-assemble in reverse order ensuring the seal is compressed evenly at the top and bottom
Re-fit the top outlet grill before re-fitting the trim and fret and before re-lighting.
CLEANING AND REPLACING Fuel Bed Parts
Important: -
Refe
r to the ‘Health & Safety Notice located on page 3 of this booklet
before cleaning or replacing any refractory material.
Use only the Fuel Bed part provided NO OTHER FUEL BED PARTS SHOULD BE
ADDED to the appliance
If any Fuel Bed Parts are broken then they must be replaced before the
appliance is used.
Note:- There is only a COAL fuel bed arrangement for the L.P.G..
Please check the label on the appliance carton to ensure you have the correct
fuel bed
The fuel bed parts are delicate and should be handled with great care.
The loose part should be removed for cleaning. They can be brushed very gently with a soft brush to
remove dust or any deposits.
A vacuum cleaner may only be used after all the loose coals have been removed.
NOTE : During operation some sooting will be evident on the fuel bed whether
running on the high or low setting. This may be reduced by running on the
opposite setting for 15 minutes prior to switching the fire off i.e. If fire is running
on high then turn to low for 15 minutes before turning off. This will not eliminate
all soot but helps keep it to a minimum.