PARA Dox CR-R880-BL, Руководство по установке

Страница: 10 / 20

8 Installation Manual
• LED and "beeper" operations are programmed via the
Centaur Access Control Software, if using another
controller refer to appropriate instructions.
• Do not use "twisted pair" with either output format.
• Pull the orange wire low to illuminate the red LED.
• Pull the yellow wire low to illuminate the green LED.
• Pull both the orange and yellow wires low to illuminate
the red and green LEDs, producing an amber colour
(an oscillation of 1KHz is required).
• Pull the brown wire low to activate the "beeper".
• Follow the recommended cable types and lengths,
listed in the technical specifications on page 3.
• For open collector (non-terminated output), consult
your system manufacturer for correct cable length and
type.
• The data out internal circuit configurations are as
shown below.
Card Presentation Test
Place the card parallel to the CR-R880-BL reader and
move it toward the reader until the card code displays on
the controller screen. At this point, the card is read,
decoded, data transmitted to the controller and the