Panther 1650, Инструкция/Каталог запасных частей

Страница: 54 / 103

P
ANTHER
MODEL PAGE NO.
1350/1650 43
SR. TROUBLE CAUSE REMEDY
4.7.3 Spindle runs
too tight and
bearing become
too hot in head
stock.
(A) Preloading of
main spindle is
not correct.
Adjust preloading of
main spindle.
4.7.4 Machine cuts
taper on job
held between
center.
(A) Tail stock
alignment not
proper.
(B) Improper machine
level.
(C) Tool worn out.
Re align tail stock.
Level machine properly.
Re grind or replace tool.
4.7.5 Gear train in
end feed
mechanism
makes sound
during running.
(A) Back lash of
change gear not
set properly.
(B) Fixing nut and
bolt not properly
tight.
(C) Some damage
mark on gear
teeth.
(D) Lubrication is not
done.
Set proper back lash
between change gears.
Tighten fixing nut and
bolt.
Inspect change gear and
deburr damage mark.
Provide proper lubrication.
4.7.6 Machine is not
able to take
heavy cut or
spindle stops
under load.
(A) Belt tension is not
proper.
(B) Safety key
sheared.
(C) Feed clutch
slipping.
Set proper belt tension.
Replash safety key in 1st
pick up gear.
Set proper spring tension
in feed clutch.
4.7.7 Noise in head
stock.
(A) Lubrication not
sufficient.
(B) Gear damage.
(C) Bearing seized or
damage.
Check oil level and
maintain proper oil level.
Replace damage gear.
Inspect and replace
bearings.