135/142
SAFETY INFORMATION FOR BATTERY USAGE
•
Do not disassemble or open crush, bend or deform, puncture or shred.
•
Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse
or expose to water or other liquids, expose to fire, explosion or other hazard.
•
Only use the battery for the system for which it is specified.
•
Only use the battery with a charging system that has been qualified with the system per
this standard. Use of an unqualified battery or charger may present a risk of fire, explosion,
leakage, or other hazard.
•
Do not short circuit a battery or allow metallic conductive objects to contact battery
terminals.
•
Replace the battery only with another battery that has been qualified with the system per
this standard, IEEE-Std-1725-2006. Use of an unqualified battery may present a risk of fire,
explosion, leakage or other hazard.
•
Promptly dispose of used batteries in accordance with local regulations.
•
Battery usage by children should be supervised.
•
Avoid dropping the phone or battery. If the phone or battery has been dropped, specifically
on the hard surface, and its damage suspects, take it to the Customer Care Center for
correct inspections.
•
Improper battery use may result in a fire, explosion or other hazard.
FCC & INDUSTRY COMPLIANCE
FCC & Industry Canada Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver. When it is ON, it receives and also sends
out radio frequency (RF) signals. In August 1996, the Federal Communications Commission (FCC) adopted
RF exposure guidelines with safety levels for mobile devices. Those guidelines are consistent with safety
standards previously set by both U.S. and international standards bodies: American National Standard
Institute (ANSI), National Council of Radiation Protection and Measurements(NCRP), and International
Commission on Non-Ionizing Radiation Protection (ICNRP). Those standards were based on comprehensive
and periodic evaluations of the relevant scientific literature. The design of your phone complies with the FCC
guidelines and applicable.
Statement according to FCC part 15.105
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Statement according to FCC part 15.19:
서식 있음: 글머리 기호 및
번호 매기기
