Panoscan MARK TWO, Инструкции по эксплуатации

Страница: 10 / 37

10
Memory Requirements
In OS-9. The ViewFinder software requires about 20,000K bytes (about 20 MB) of memory to
operate,
as shown in its Get Info window. There is no performance advantage to assigning additional
memory to the control software application. For proper operation, VIRTUAL MEMORY MUST BE
TURNED OFF.
Scan to RAM Mode
For scans to be taken directly to the host Macintosh’s RAM, enough uncommitted (not already
assigned to any application) RAM memory must be available to hold the desired image size for the
scan. The amount of uncommitted memory may be determined from the “Largest Free Memory”
field within the “About this Macintosh” menu selection. Otherwise, the “Scan to RAM” checkbox
will be disabled (grayed out) in the main control window. If enough free memory exists, the control
software will “borrow” it from the System for the duration of the scan, and then release it back to the
System after writing the new image data to the computer’s internal disk drive.
System Requirements
Macintosh Computer
G3 processor or better (iBook and Powerbook supported.)
Mac OS 9.2 or OS-X 10.2 or later. (Classic mode in X NOT supported.)
24-bit color graphics display and video card with 1024 x 768 minimum resolution
SCSI-2 Interface (HD-50), or Firewire converter provided by Panoscan.
128 MB RAM minimum (additional RAM required for Scan to RAM operation)