SMARTZONE G5 USER MANUAL
9
Section 2 – Remote Configuration
Dynamic Host Configuration Protocol (DHCP)
The PDU is Dynamic Host Configuration Protocol (DHCP) compatible. If the network
does not use a DHCP server, see the CONNECTING THROUGH A SERIAL
CONNECTION section. The PDU automatically obtains an IP address via DHCP, when
connected to a network. Login to the Web interface to configure the PDU and assign a
static IP address (if desired). The PDU automatically gets an IP address and displays it
on the LCD screen. If there is no DHCP server, the default IP address is 192.168.0.1,
but again this will be displayed on the PDU.
1. Connect a standard Ethernet patch cable to the Ethernet port on the PDU.
2. Connect the other end of the Ethernet cable to the LAN.
3. Make sure the Ethernet port on the PDU shows a solid green light on the left and a
flashing yellow light on the right to indicate successful connectivity to the network.
4. Use the menu buttons to look up the IP address of the device on the OLED display
by selecting Setup > Network > IPv4 or IPv6 as applicable.
5. In a standard web browser, enter the PDU IP address and proceed to configure the
PDU as shown in the Web Configuration section.
Web Configuration
Supported Web Browsers
The supported Web browsers are Windows Firefox, Linux Firefox, Windows Internet
Explorer, and Google Chrome.
Logging in to the Web Interface
Logging In
•
Open a supported web browser and enter the IP address of the PDU.
o
If username and password were configured during the Network Configuration
Setup: enter the username and
password in the appropriate fields. Press
Login
or
Enter
.
o
If username and password were NOT configured during the Network
Configuration Setup, use the default username:
admin
and password:
12345678
. For security purposes, change the password upon login.
Содержание smartzone G5
