© Panduit Corp. 2018
OPERATION MANUAL
PES400
ENGLISH
PES400: PA28981A01_01
Page: 19 of 46
4-2018
Figure 2
1.72" (43mm) Plate Width
4.2.5 Plate Support Block Changeover
a. Find the correct Plate Support Block from [
Table 1
], [
Figure 3
] and
[
Figure 4
], for the embossed marker plate.
b. Loosen RH Side Knob [
Figure 1
] and move right hand side wall out of the way
[
Figure 5
] by pushing on the bottom of the wall assembly.
c. Loosen thumbscrew underneath plate support block reaching through side
eject plate [
Figure 6
].
d. For easier access, slide the plate support block right (from top side), then
remove thumbscrew with washer and Plate Support Block.
e. Remove thumbscrew(s) from Plate Support Block to be inserted.
f. Hold a thumbscrew in slot and align plate support block to the right of the guide
slot [
Figure 7
]. Insert thumbscrew into the bottom of the block, but do not
tighten fully [
Figure 8
].
g. Slide the block until snug against left gate, then tighten fully.
h. Slide right hand side wall until it is snug against the support block and tighten
RH Side Knob.
i. Ensure top of plate support block is level with side supports. [
Figure 9
] and
[
Figure 10
]
