Pandora MINI MOTO
WIRING DIAGRAM
micro-USB Antenna
2.4GHz (BT 5.0)
WARNING!
Do not shield
the built-in antenna when
installing the system and
additional devices. Keep
minimum distance of 2 cm
between the modules
and metal parts.
WARNING!
Update firmware of the
base unit before installation. If the
CAN-bus connected, choose the vehicle
model code.
WARNING!
The installation locations of
the base unit and system elements must
meet their temperature, dust- and
moisture-protection characteristics. The
base unit and blocking relay are
designed to operate at temperatures
from -40°C to +85°C, the degree of
protection is IP54.
WARNING!
The base unit must be placed
vertically or horizontally, do not cover
the front side of the unit (the side with
the «Pandora» sign).
WARNING!
The system is a
maintenance-free device. In case of
failure you must immediately contact
your local supplier.
WARNING!
All wireless accessories from
the kit are already paired with the base
unit. The maximum number of paired
Bluetooth accessories is 14.
CAN-H
CAN-L
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16
INP2
/CH4
– «NC blocking» output
200mA (—)
v 1.0
POWER SUPPLY (—)
POWER SUPPLY (+12V)
10A
CH6
– «Turn lights» output
7.5А
6A (+12V)
CH7
– «Turn lights» output
7.5А
6A (+12V)
CH1
/INP4
– «Clutch» input
200mA (—)
clutch switch
to the original wiring
(+)
INP3
– «Brake» input
CH5
– «Siren» output
2A (+12V)
INP1
– «Ignition» input
(+)
Engine temperature sensor
Magnetic reed sensor
when connecting the sensor,
set type of the «Trunk» input as NC
CH3
/
INP6
– «Trunk» input
CH2
/
INP5
– «Trunk» input
200mA (—)
200mA (—)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Red
Black
White
White/Red
Yellow
Green
Grey
Orange/Black
Orange
Orange
Violet
White/Green
White/Blue
White/Brown
Brown
White/Orange
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16
86
85
30
87 87a
+12В
NC
COM
NО
External
button
Green/Black
Green/Red
Gren
BASE UNIT
PLACEMENT
IT IS FORBIDDEN
to install the system
on a vehicle with normal voltage other
than 12V.
IT IS FORBIDDEN
to install the system
with damaged output cables.
WARNING!
Fixate the protective cap
using clamps when the installation is
finished. Isolate the protective cap and
wires with the insulating tape.
WARNING!
All power circuits of
additional devices that are not powered
through the base unit of the system
should have their own fuses.
IS FORBIDDEN
to change or bypass original
fuses of a system in the installation process.
IT IS FORBIDDEN
to install the temperature
sensor at the place where temperature is
higher than the operating range of the
sensor (+125°C) and cable (+80°C).
IP40
(not included in the kit)
