EN
- 34 -
To request technical support, under guarantee or otherwise, call the above telephone number, or
send a fax or e-mail. You are informed that service will only be covered by the guarantee where the
problem is a defect in the product.
The following are not covered by the guarantee, and in these cases the costs of labour and
call-out of the technical support service must be paid for:
problems arising from poor installation of the hood or extraction flue, inspections of installation or
operation, cleaning, consumables which wear out such as filters and bulbs, decorative components
such as light shades, glass, etc., faults caused by variations in the power supply.
8. TECHNICAL AFTER-SALES SERVICE, GUARANTEE CERTIFICATE AND
REGISTRATION OF YOUR HOOD:
TECHNICAL AFTER-SALES SERVICE:
INOXPAN S.L.
TELF. +34 902 415 510 / FAX: +34 937 579 653
E-MAIL: [email protected]
USER ADVICE TO AVOID OR MINIMISE CONDENSATION:
(This advice is useful providing the flue and hood are properly installed, and a motor system with
the right power rating has been chosen)
A) The hood should be switched on 5 minutes before starting to cook and the timer (LAST TIME) set
after finishing cooking to clear the fumes held in the flue. This will clear it out fully.
B) Do not use the hob to cook at full power straight away, i.e. start on low or medium power to give the
steel in the bottom of the hood time and external parts to heat up. If the type of cooking generates large
amounts of steam, use the hood at full power.
C) Keep the filters clean, cleaning them at least every 10 days, and replace them if they begin to
deteriorate, in accordance with the manufacturer’s recommendations and timescale.
D) Have a constant flow of air into the room (ventilation grille, half-open window, etc.) to avoid the
creation of a depression which would affect the rate of aspiration.
E) Follow the advice in the instructions for induction systems as regards the effects of condensation.
INOXPAN S.L. takes no responsibility for the proper functioning of its products if they are not con-
nected to a flue pipe of the correct diameter as shown in the table of flue diameters for each motor
version.
