INSTALL GOLD MOUNT BATTERY
1. Install the DXL Hot Swap Module. For more information, go to
"Install a DXL Hot Swap Module" on the previous page
.
2. Slide the battery onto the DXL Hot Swap Module, ensuring that the Gold Mount T-studs are aligned in the corresponding
slots.
The latch clicks when the battery is installed.
REMOVE GOLD MOUNT BATTERY
1. While holding the battery, push down the black latch on the left side of the DXL Hot Swap Module.
2. Slide the battery to the left to remove the battery.
SLIDE BATTERY PLATE UP AND DOWN
The battery plate slides up and down the module, and can be locked into any position on the slide. The highest position is
ideal for studio shoots, and the lowest position is ideal for hand-held shoots. To slide the battery plate, follow the instructions
below:
1. Move the silver lever at the top of the DXL Hot Swap Module toward the right side (Assistant side) of the camera.
2. Slide the battery plate into the position you want it.
3. To lock the battery plate into place, move the silver lever at the top of the DXL Hot Swap Module toward the left side
(Operator side) of the camera.
RECORD
Perform one of the following actions to begin recording:
Press PWR/REC on the camera.
Press REC on the media bay.
Enable record via RCP.
GPI through 7 pin AUX port
3 pin Fischer R/S through front 24v ports
COPYRIGHT © 2017 PANAVISION INTERNATIONAL, L.P.
FW: V-0.5.35
|
27
PANAVISION MILLENNIUM DXL
Содержание Millennium DXL
Страница 1: ...PANAVISION COM...
