Panasonic YD-500KR, Руководство по эксплуатации

Страница: 12 / 51

10
CONNECTION
Welding Source Switch Box
Be sure to observe the following in order to avoid a burn or an accident resulting in injury
or death.
 Prior to connection work, be sure to turn off the switch of the switch box and make
sure or safety.
 Do not touch with a wet hand.
 Electrical connection work and grounding work should be carried out by a qualified .
In order to prevent a fire or burn-out of the device due to overheat of the cable or to prevent
generation of unstable arc。

Use the cable of the specified thickness or more. (Refer to page 10)

Do not place a heavy substance on the cable or bring it into contact with a weld Zone.

Tighten securely a cable joint.

This machine has input power frequency select switch. Please confirm the correct
position of the switch. (Refer to pages 27,28 and 30.)

When a frequency changes depending on where you use the welding source, switch to
an adequate frequency.
Welding Torch
Base Metal
Safety Warning
① Loose the left and right
screws to remove the cover.
⑤Connect input cables(3 of them) to
the switch with fuse or no-fuse
breaker (or leakage breaker).
② Connect the input
cables (3 of them) to
the input terminals.
3-phase rated
input voltage
③Tape around any exposed
conductive sections which
may come into contact with
other parts
Welding Power Source
Switch
Box
Cover
Input
⑥Ground with cable
④Attach the cover
Caution