Panasonic YD-350GL4, Руководство по эксплуатации

Страница: 18 / 58

14
NO. name description
○
8
manual wire
feeding button
●The function is used to feed welding wire into the liner before welding
by holding this key.
・
manual wire feeding speed is decided by the welding current.
○
9 switching button
●To switch the setting among“ initial ”, “ Weld ”, “ crater ” current.
・
For crater OFF, it can not be switched. Only the setting for “ Weld ”
current can be selected.
○
10 gas check button
● It is to check shield gas and adjust flow rate.
• Normally, the indicator lamp is off. The lamp is on while checking gas.
• To perform the gas check, press this button and then release, then the gas
valve of the wire feeder is turned ON and then turned OFF in 20 seconds.
Press this button once again to terminate the gas check immediately.
○
11
lock button
● During stand-by, long press button for 1 second to lock the panel. Then
all buttons on the panel expect
○
3
○
6
○
8
○
9
○
10
can NOT be operated but the
wire feeder potentiometer can be adjusted.
○
12
mode select
button
● Weld: welding condition setting for
○
2
～ ○
7
,
○
9
and
○
13
～ ○
17
,
○
8
○
10
for wire feeding check, gas check for welding,
○
11 for panel lock
・
F. Adj: fine adjustment on F. Adj menu ( Section 5.4).
・
Call: To call the welding condition being recorded ( Section 5.4).
・
Record: To record the present welding conditions ( Section 5.4).
○
13 welding control
●For welding control method selection, ( Chapter 8 )
・
crater OFF: regular welding.
・
crater ON: regular welding
～
crater welding.
・
initial ON: initial welding
～
regular welding
～
crater welding.
・
spot welding: The welding lasts certain seconds according to the spot
welding time being set. The welding stops automatically when the spot
welding time is up.
○
14 welding method
●To select the welding method
・
pulse OFF: No pulse during welding.
・
pulse ON: pulse is turned on during welding.
・
root welding: NO pulse root welding 1.
※
・
Deepen: NO pulse deep penetration 1.
※
○
15
material
● select the material to be welded
・
OP1 and OP2 are reserved for special design.
○
7 Jog-dial
● When Mode selection key
○
12
is set to“ Weld ”, (please refer to the
description in ○ 6)
・
When key ○ 6 selects different options, please adjust corrosponding set
value according different items.
・
During welding, the contents in
○
8
can be adjusted. However,
“ initial ” and “ crater ” current change not be changed.
●When Mode selection key
○
12
is set to “F. Adj”, ( Section 5.4)
・
Refer to detailed description.
●When Mode selection key
○
12
is set to “ Call ”,
・
select Call channel number. (Only the channel number being recorded
in
○
5
can be shown. )
●When Mode selection key
○
12
is set to “ Record ”,
・
Record channel number is select.
Names and functions