Installation
7
3.
Installation
3.1
Transportation
3.2
Installation site
3.3
Power supply equipment
When hanging this product for transportation, hang it at two eyebolts.
●
Do not lift the product on your own.
As this product is heavy, it is dangerous to lift it on your own. Involve plural number of
persons with its lifting.
●
Do not leave the product on a slope.
(The product is provided with casters.)
●
When pushing this product for transportation,
do not make a sharp turn
, or casters
or floor may be damaged.
CAUTION
This product is designed for indoor use only.
Do not install it in any places subject to rain or water spray.
In case that the product gets wet with rain or water spray:
Make sure that persons who well understand this product should check the inside of the product and wipe up water
if any. Such water entered inside the product may cause the product to malfunction.
●
Indoors, not subject to direct sunlight or rain, with less
moisture and dust.
●
Ambient temperature: -10
℃
to 40
℃
●
Maintain an appropriate distance of 20 cm or more from
any wall or other devices.
●
Maintain an appropriate distance of 30 cm or more
between power sources installed side-by-side.
(Install this product in the horizontal position.)
●
Places where the welding arc area is not subject to
wind. (Protect the area from wind by a partition, etc.)
●
Places where the product is not likely to take in metallic
foreign substances
Note
When the product, which is installed on the floor, is too low
to operate, customers are required to prepare a table to
mount it. (And, in that case, provide such a table with a flange,
etc. so that the product does not slip down from the table.)
CAUTION
Observe the following to prevent burnout, destruction of parts and unstable
arc.
Input protective devices
(Breaker, fuse etc.)
Type and capacity to be applied should conform to all national
and local codes.
Cable cross section area
for input cable and ground wire
Type and size of cables to be applied should conform to all
national and local codes.
Input voltage
380 VAC(YD-350GL4and YD-500GL4)
Содержание YD-350GL4
Страница 45: ...41 1 2 3 4 5 6 7 8 9 10 11 12 13 14 14 40 41 43 44 45 Right view Left view Parts list ...
Страница 49: ...45 1 2 3 4 5 6 7 8 9 10 11 12 13 14 14 40 41 43 44 45 Right view Left view Parts list ...
Страница 52: ...Circuit diagram 48 13 Circuit diagram 13 1 Circuit diagram for 350GL4 100V 100V Optional parts 300 246 ...
Страница 53: ...Circuit diagram 49 13 1 Circuit diagram for 500GL4 100V 100V Optional parts 300 248 ...
