19
ENGLISH
■
Repeater installation procedure
Before installing the repeater, for its optimal use, follow the steps below to temporarily
install it in advance and ensure that the area where it is needed is covered.
1
Advance preparation
Register all of the All-In-One Headsets or Belt Packs and repeaters to the center
module. (page 25)
2
Check the connection with the center module
Temporarily install the repeater and supply power to the repeater with the USB power
adaptor (commercially available).
The repeater connects to the center module after turning on the power.
Check the lighting status of the [STATUS] indicator on the repeater.
●
If the [STATUS] indicator on the repeater is orange or green, there is sufficient signal
strength and the location is suitable for installation.
●
If the [STATUS] indicator on the repeater is blinking orange or green, the location
needs to be adjusted for installation.
Move the repeater to a location where the [STATUS] indicator on the repeater
changes to solid orange or green.
Unplug the USB power adaptor to stop the power supply, move the installation
location of the repeater closer to the center module, then supply power again from
the USB power adaptor.
Check whether the [STATUS] indicator on the repeater is orange or green.
3
Check the connections with the All-In-One Headsets or Belt Packs
Check whether the All-In-One Headsets or Belt Packs are able to be used in the range
anticipated by the user within the coverage area of the repeater.
4
Install using the repeater fixing bracket (page 21)
Once the connections with the center module and All-In-One Headsets or Belt Packs
have been confirmed, mount the repeater using the repeater fixing bracket.
WX-CR480P_PUQX1029ZAV1_OI_en-fr.indb 19
2021/11/08 13:25:15