20
⑤
Alarm input/output cable / 8P alarm cable (accessory)
<Ratings>
• Alarm input1 / Black & white input / Auto time adjustment input, Alarm input2, Alarm input3
Input specification : No-voltage make contact input (4 V – 5 V DC, internally pulled up)
OFF
: Open or 4 V – 5 V DC
ON
: Make contact with GND (required drive current: 1 mA or more)
• ALARM OUT, AUX OUT
Output specification : Open collector output (maximum applied voltage: 20 V DC)
ON
: 4 V – 5 V DC by internal pull-up
OFF
: Output voltage 1 V DC or less (maximum drive current: 50 mA)
8P alarm cable
IMPORTANT:
• Install external devices so that they do not exceed the rating of the camera.
• When using the ALARM IN2 and/or 3 as the output terminals, ensure they do not cause sig-
nal collision with external signals.
Note:
• Off, input, and output of the ALARM IN2 and 3 can be switched by configuring the setting.
Refer to the Operating Instructions on the Panasonic support website for further information
about the ALARM IN2 and 3 settings (“Off”, “Alarm input”, “Alarm output” or “AUX output”).
Connect the 8P alarm cable (accessory) to the alarm input/output cable. Then, connect the exter-
nal device cable to the 8P alarm cable.
ALARM IN1 (Alarm input1 / Black & white input / Auto time adjustment input) (Black)
GND (Brown)
ALARM IN2 (Alarm input2 / Alarm output) (Red)
GND (Orange)
ALARM IN3 (Alarm input3 / AUX output) (Yellow)
GND (Light blue or green)
Unused (Blue)
Unused (Purple)
Note:
• The audio output can be switched to the monitor output. Refer to the Operating Instructions on
the Panasonic support website for descriptions of how to switch the output.
• The video output is set to NTSC in the default settings of the camera. If you want to change
the video output setting to PAL, refer to the Operating Instructions on the Panasonic support
website.
