25
Note:
• When the zoom lock knob is adjusted to
the WIDE side and the tilt angle is approx.
±75 °, 1/3 part of the screen may be hid-
den.
Important
• Tighten the panning table lock screw and
tilting lock screw. (Recommended tighten-
ing torque: 0.59 N·m {0.44 lbf·ft})
e
Rotate the azimuth adjuster to adjust the
azimuth angle of the image (Range:
±100°).
x
Zoom and focus adjustment
At the same time as adjusting the pan and
tilt(Step 2), adjust the zoom and focus.
TELE
TELE
WIDE
WIDE
FAR
FAR
NEAR
NEAR
This illustration represents WV-CW364S.
q
Loosen the zoom lock knob and move the
knob between TELE and WIDE to obtain
the appropriate angle of view. Tighten the
zoom lock knob.
w
Loosen the focus lock knob and move the
knob between FAR and NEAR to obtain
the optimum focus. Tighten the focus lock
knob.
Note:
• To change the angle of view by moving the
zoom lock knob, also move the focus lock
knob to adjust the focus.
c
Mount the dome cover and inner
dome.
Tighten the screws that have been loos-
ened in Step 2 in page 22 using the sup-
plied driver bit.
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Important:
• Attach the inner dome in accordance with
the lens direction to not to change the lens
direction.
• Check if the tabs of the inner dome are
firmly fit.
• Remove the protection sheet from the out-
side of the dome.
Cutout for
mounting
Groove for
mounting
Azimuth adjuster
Rotating angle:
–100 °
Rotating angle:
+100 °
Indication
