10
Precautions for installation
Panasonic assumes no responsibility for
injuries or property damage resulting from
failures arising out of improper installation
or operation inconsistent with this docu-
mentation.
Installation work shall be performed in
accordance with the technology standard
of the electric installation.
This product is designed to be installed
under eaves.
Keep the product out of direct sunlight.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is
strong enough to hold the product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• If a ceiling board such as plaster board is
too weak to support the total weight, the
area shall be sufficiently reinforced.
Avoid installing this product in the follow-
ing locations.
• Locations where a chemical agent is used
such as a swimming pool.
• Locations subject to steam and oil smoke
such as a kitchen, Locations near flamma-
ble gas or vapor.
• Locations where radiation or x-ray emis-
sions are produced.
• Locations where corrosive gas is pro-
duced, Locations where it may be dam-
aged by briny air such as seashores.
• Locations where the temperature is not
within –10 °C to +50 °C {14 °F to +122 °F}.
(When using the optional heater unit, the
product can be used at temperatures with-
in –30 °C to +50 °C {–22 °F to +122 °F}
and humidity below 90 %.)
• Locations subject to vibrations (This prod-
uct is not designed for on-vehicle use.)
Avoid moist or dusty places to install this
system.
Otherwise, lifetime of the internal parts may be
shortened.
Avoid installing the camera in a place with
a high level of noise.
Installation near an air conditioner, an air clean-
er, a vending machine, or the like causes noise.
Be sure to remove this product if it is not
in use.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Radio interference
When this product is used near TV/radio anten-
na, strong electric field or magnetic field (near a
motor or a transformer), images may be dis-
torted and noise sound may be produced.
In such a case, run the camera cable through
specialized steel conduit tubes.
Locally procure the screws
Screws are not supplied with this product. Pre-
pare the screws according to the material,
structure, strength and other factors of the
mounting area and the total weight of objects
to be mounted.
The following points as well as the contents of "Warning" and " Caution" shall be
observed.
