24
Adjust the camera
z
Pan, tilt and azimuth adjustment
Important:
• Do not touch the iris motor. Failure to
observe this may cause trouble.
• Do not hold the camera by the lens unit
when adjusting panning, tilting, or azimuth.
Detach the inner dome from the camera by
picking the front and rear sides.
Note:
• Do not touch the lens.
At the same time as the pan and tilt adjust-
ments, make the zoom and focus adjustments
in Step 2.
q
Rotate the panning table to adjust the pan-
ning position of the camera. (Range: 320°)
• The adjusting range is from +180 ° (clock-
wise) to –140 ° (counterclockwise).
• Tighten the panning table lock screw after
adjusting
w
Rotate the tilting table to adjust the tilting
position of the camera (Range: ±75 °).
• This lens can also be rotated in the reverse
direction, but the image azimuth is
reversed. In such a case, turn the panning
table to the 180 ° side to correct the azi-
muth image.
• When used at an angle that is close to hor-
izontal, it must be noted that the shadow
of the dome cover may be projected.
• Fasten the tilting lock screws of both sides
after adjusting.
Pick the portion marked
in the illustration as well
as the opposite side.
Pick the portion marked
in the illustration as well
as the opposite side.
CW: +180 °
Panning lock screw
Panning table
CCW: –140 °
Indication
: CCD up side
Tilting lock
screw (x2)
Variable tilt angle: ±75 °
