![background image](http://html.mh-extra.com/html/panasonic/wv-cs650/wv-cs650_operating-instructions-manual_277857012.webp)
- 9 -
(7) White Balance (WHITE BAL)
You can select one of two modes for white balance adjustment as follows:
• ATW (Auto Tracing White Balance)
In this mode, the colour temperature is monitored continuously and thereby white balance is set
automatically. The colour temperature range for the proper white balance is approximately 2 600 -
6 000K. Proper white balance may not be obtained under the following conditions:
1. The colour temperature is out of the 2 600 - 6 000K range.
2. When the scene contains mostly high colour temperature (bluish) objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
• AWC (Automatic White Balance)
In this mode, accurate white balance is obtained within a colour temperature range of approx. 2 300
- 10 000K.
Note:
See page 26 for the setting.
(8) Motion Detector (MOTION DET)
The Motion Detector detects the motion in the scene by monitoring changes in the brightness level.
You can select the level of sensitivity for motion on the SET UP menu.
When this camera is connected to a compatible intelligent CCTV system, the camera transmits an
alarm signal by multiplexing it with the video signal.
When the camera detects the motion in AUTO, it supplies the alarm signal to the external equipment
and stops at its position for the preset dwell time. You can select the dwell time as follows;
OFF 1/2/3/5/10/20/30/60 min.
Note:
See page 27 for the setting.
(9) Auto Focus (AF MODE)
You can select one of two AF modes as follows:
MANUAL:
AF mode is activated by pressing the AF button of the controller.
AUTO:
AF mode is activated automatically after a manual panning, tilting or zooming operation.
Notes:
• AUTO in AF MODE is disabled unless SENS UP is set to OFF. If SENS UP is not OFF, AF MODE
is set automatically to MANUAL.
• See page 28 for the setting.
(10) Special Menu (SPECIAL)
This menu allows you to adjust the following items: upside down, chroma level, aperture level and
pedestal level. You can also reset your parameters to the values preset at the factory.
See page 29 for the setting.